TransDEM Forum

I have just imported a new DEM into TANE from TS12. In TS12 it looks fine with 3D tiles, but once imported into TANE the ground textures are invisible. The 3d tiles can be seen though the ground and I sunk 1 tiles to show what is happening on the pictures below.

I did install the TANE textures download, but I don't have TransDEM installed in the default location. Is this a problem for the installer?

Thai1On wrote:I did install the TANE textures download, but I don't have TransDEM installed in the default location. Is this a problem for the installer?

Yes, that can be a problem for this particular installer.

Check your TransDEM installation directory and the "TransDEM-Ground-Textures" subdirectory. You should find
TransDEM Ground Textures Orthoimagery 128 V2.cdp
TransDEM Ground Textures V5.cdp
both dated Jan 19, 2015.
If you you don't see those the installer failed. (It should have thrown an error message.)

In case installation did not succeed, manually adjust the installation path in the installer wizard page captioned "Select Destination Location". Make sure you don't end up with "Ziegler-Tools" twice in the path. (The installer may add this part itself.)

Thank you Dr. that fixed it!

Dave