TransDEM Forum

Hi All,
Following the TransDem manual to the letter I became confused over one entry.

It states.
Select Settings from the file menu and go to the Miscellaneous Tab. It is called "Enable hardware accelerated texture compression"
End Quote:

I run TRS12, build 58414, and no such box exists, there, or in any other other tab in TRS12. CM or the main program.

I would hate to load the ground textures ETC; and a trial route only to find a blank/black monitor.
If anyone runs the same version of TRS12; I would appreciate any advice they can give me
Cheers
Scorp.

scorpio48 wrote:I run TRS12, build 58414, and no such box exists, there, or in any other other tab in TRS12. CM or the main program.

I think you are right, this option appears to be gone. I haven't experienced any problems myself without this option and nobody else reported difficulties here in recent months.

geophil wrote:

scorpio48 wrote:I run TRS12, build 58414, and no such box exists, there, or in any other other tab in TRS12. CM or the main program.

I think you are right, this option appears to be gone. I haven't experienced any problems myself without this option and nobody else reported difficulties here in recent months.

Thank you Roland,
I have only just been cleared to use this forum, so I sent you an email regarding the above.
Please ignore it.
Thanks Again
Pete.