TransDEM Forum https://forum.transdem.de/ |
|
How to use Reuse Existing KUID in Ground Texture Exporter https://forum.transdem.de/viewtopic.php?f=7&t=638 |
Page 1 of 1 |
Author: | DmitryKz [ 19 May 2022 18:16 ] |
Post subject: | How to use Reuse Existing KUID in Ground Texture Exporter |
Hello. Please clarify my confusion about the using of the Reuse existing KUID option in Ground Texture Exporter. I assumed that this option enabled would cause the same map (ie with the same name) in the export directory to be overwritten without changing the kuid. But I am faced with the fact that the number of the kuid is always incremented by 1 (ie the second group of numbers — after the user ID). Please tell me what I'm doing wrong and how to do it right. |
Author: | geophil [ 19 May 2022 18:48 ] |
Post subject: | Re: How to use Reuse Existing KUID in Ground Texture Exporte |
I have checked the code: TransDEM looks for an existing route with the desired name in the specified export folder and its sub-folders and will take the KUID from config.txt. If the reuse option is set, it will not assign a new KUID. Just tested it and it works for me. |
Author: | DmitryKz [ 20 May 2022 03:55 ] |
Post subject: | Re: How to use Reuse Existing KUID in Ground Texture Exporte |
Please watch the video, maybe you will notice what I'm doing wrong. https://youtu.be/BdCaLCnsIBE |
Author: | geophil [ 21 May 2022 17:57 ] |
Post subject: | Re: How to use Reuse Existing KUID in Ground Texture Exporte |
I suggest not to change the KUID manually when exporting the second time. It may override other settings. |
Author: | DmitryKz [ 22 May 2022 03:19 ] |
Post subject: | Re: How to use Reuse Existing KUID in Ground Texture Exporte |
Yes, of course, I did that too. But nothing changes, the same behavior is the continuing increment of kuid. Here, I repeated the test again without manual intervention (except at the very end in the last iteration) and on a different operating system:: https://youtu.be/F__vqaDMLa8 I did all this on two operating systems: Windows 7 and Windows 10 - I always got the same thing. To be honest, I noticed it even after purchasing TransDEM - but then I didn’t attach any importance to it, I just did a Reset, since I built only one route and it was easier to press the Reset button than to figure it out. |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |