| TransDEM Forum https://forum.transdem.de/ |
|
| Vectors showing in surveyor https://forum.transdem.de/viewtopic.php?f=7&t=299 |
Page 1 of 1 |
| Author: | Redford1998 [ 17 Mar 2014 02:23 ] |
| Post subject: | Vectors showing in surveyor |
I cant seem to figure this out but the vector lines aren't showing on the ground in surveyor. |
|
| Author: | geophil [ 17 Mar 2014 16:22 ] |
| Post subject: | Re: Vectors showing in surveyor |
What do mean by "not showing"? Nothing at all? Not even spline control points? If you have control points the layer may be deactivated or the KUID you used is not installed or does not refer to a regular spline asset. If there is nothing to be seen at all, nada, make sure you exported to the right incarnation of your route. There is this risk of duplicate entries in the UserData/Editing folder. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|