| TransDEM Forum https://forum.transdem.de/ |
|
| smooth spline height issue https://forum.transdem.de/viewtopic.php?f=7&t=696 |
Page 1 of 1 |
| Author: | roadwarrior104 [ 01 Jan 2024 13:11 ] |
| Post subject: | smooth spline height issue |
so when i smooth the spline height in the route i created it brings the ground up to the top of the rails no ballast or ties visable tried with different track tried this on a installed route though maybe it was trainz 22 but it works right on installed routes and i just look in my save on my route and there are a bunch of unknown assets that have your kuid well i figured something out its the textures that is above the ties and ballast not the actual ground when i go to wire frame the ground is in the place its suppose to be so how did i end up with the textures above the ground |
|
| Author: | geophil [ 03 Jan 2024 15:19 ] |
| Post subject: | Re: smooth spline height issue |
The best way seems to "adopt terrain height" when exporting splines. Vertical alignment used to be automatic in earlier versions of Trainz, unfortnately it no longer is. |
|
| Author: | roadwarrior104 [ 03 Jan 2024 16:26 ] |
| Post subject: | Re: smooth spline height issue |
i will try again but as i said when i go to wireframe the track is in the right place its like the textures are above the ground i did put it on adapt height but its when you hit smooth ground under spline the texture/paint goes over the ties/ballast not the actual ground in wireframe the ground is in the correct place |
|
| Author: | roadwarrior104 [ 05 Jan 2024 21:01 ] |
| Post subject: | Re: smooth spline height issue |
its the transdem ground textures in 22 when i paint over them with in game texture it fixes it |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|