TransDEM Forum https://forum.transdem.de/ |
|
Not seeing track, route or all of the grid https://forum.transdem.de/viewtopic.php?f=7&t=482 |
Page 1 of 1 |
Author: | JamesonBolmara [ 12 Feb 2017 22:29 ] |
Post subject: | Not seeing track, route or all of the grid |
Greetings, I created my first route using the Map Services, following the instructions in the Tutioral. Everything went smooth however, after importing into T:ANE I can see the map: http://prntscr.com/e7wycx yet when zooming in I get this: http://prntscr.com/e7wzp6 and this: http://prntscr.com/e7x06m. I can see the terrain has taken the shape but where did my route and track go? And why is the map not showing everywhere? I exported the following: DEM and Ground Textures, UTM Tiles and Track Spline I'm sure I've messed up somewhere. Thanks for your help, Bill |
Author: | geophil [ 12 Feb 2017 22:50 ] |
Post subject: | Re: Not seeing track, route or all of the grid |
Did you install the TransDEM ground texture set, as requested in the Quick Start Guide, Preparation, 1st step? The TransDEM Trainz manual has the detailed instructions, on page 14. |
Author: | JamesonBolmara [ 12 Feb 2017 23:49 ] |
Post subject: | Re: Not seeing track, route or all of the grid |
DOH, I feel foolish... I did all this for setting it up in TMR17 but forgot to do the Trainz Setup for T:ANE... my bad... Bill |
Author: | geophil [ 13 Feb 2017 09:22 ] |
Post subject: | Re: Not seeing track, route or all of the grid |
BTW, I do not recommend using ortho-imagery for ground textures. The ground textures, technically limited to one pixel per ground vertex, 5 or 10m, won't be sharp enough to resolve the photo, and there will not enough colours either. It's usually better to use a map for ground texturing, Open Street Map will often be a good enough choice, and ortho-imagery for UTM tiles. You may want to play around a bit and compare the results. |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |